RECENT POSTS

Dynaudio、4月1日からの新価格を発表。

国内ニュース速報 [Japan]

Dynaudio製品の4月1日以降の新価格は以下のとおりです。

dynapr

avantgarde、「 uno fino 」国内登場!!

国内ニュース速報 [Japan]

avcantgarde uno fino
\1,900,000(ペア・税別)

av1

av2

 

 

 

CH precision、外部電源ユニット「 X1 」の内部を少し公開!!発売間近。

海外ニュース速報 [World]

CH Precisionの外部電源ユニット「 X1 」が数か月以内に発売開始予定ですが、その内部写真を少し公開です!!

ch1

ch2

ch3

 

Avalon、tesseract国内登場!!!

国内ニュース速報 [Japan]

Avalonの新フラグシップ、tesseractが国内登場です。

テッサラクト

\40,380,000(税別)   予価  2013年7月~8月出荷予定

DSC_0010

 

GOLDMUNDから、「 Telos 500 」 登場!!

海外ニュース速報 [World]

gtelos500b

TECHNICAL SPECIFICATIONS

POWER SUPPLY
· Nominal Line Voltage 117 ; 234V
· AC line range: 10%
· Fuse 16A for 115 and 230V
· 10 toroidal transformers
· Separated ground and earth signal
· Connection between earth and ground to cancel all ground loops
Rated power consumption:
· IEC 60065, 1/8 Output Power at 8 Ω: 210 W
Max power consumption:
· IEC 60065 at 8 Ω /1% THD: 550 W
FRONT PANEL
· 2 control keys
· Red led display for Over-heating, DC offset or HF protection and Overload
· Green led display for Power ON, operating mode
· Yellow led display for AC line connection and digital Lock
· Yellow led display for Standby Mode
REAR PANEL
· Power cord: universal socket 3 lugs
· Main fuse (16 A slow-blow)
· Green-yellow AC earth binding post
· Output speaker 1 x 5 ways post
· Output speaker 1 x coaxial connector
· Analog Input connector RCA
· Input connector XLR for analog balanced input
· Digital input and output RCA connector
INPUT
Max level before clipping:
· Analog input: 1Vrms
· Digital input: – 6 dBFS
OUTPUT
Max level before clipping:
· 1 % THD, unloaded: 153 Vpp
PERFORMANCE
Output power:
· Power RMS (Goldmund FPP Standard): 350 Wrms on 8 Ω.
· Maximum power (IEC60065): 335 Wrms on 8 Ω / 1%THD
Bandwidth:
· 20Hz – 20KHz: +/-0,03dB, unloaded
· +/- 3dB: 0Hz to 100 kHz (limited by protection circuitry), unloaded
Slew rate:
· Unloaded,18V/μS
Distorsion:
· IMD (SMPTE), unloaded: < 0.03 %
· THD+N, unloaded: < 0.06 % from 20 Hz to 20 kHz at 20 Vrms output
Output noise floor:
· Analog input terminated with RCA Shorting Caps, unloaded: < 3 μV from 20 Hz to 20 kHz
Gain:
· 35dB
Dynamic range:
· 22 kHz measurement bandwidth (flat), true RMS unloaded: 110 dB
Damping factor:
· at 8 Ω: > 160 from 20 Hz to 20 kHz
DIMENSIONS
· 330 W x 470 D x 270 H (mm)
WEIGHT
· Weight: 65 kg
WARRANTY
· 3 years parts and labo

 

goldmund_telos_500_user_manual

 

 

Lansche Audioから、「 No 8.2 」登場。

海外ニュース速報 [World]

$260,000 ハイエンド2013(5月)にて発表予定。

Lansche No8_2_2

lan2

Dan D’Agostino、MOMENTUM PREAMPLIFIER を発売開始。

海外ニュース速報 [World]

*日本国内での発売開始時期については未定です。
*以下は、自動翻訳エンジンにて英語に変換しております。

Preamplifier MOMENTUM

Why only the Momentum preamp can match the exceptional quality amplifiers Momentum? Because it is the only preamp built according to the same standards. Dan D’Agostino, probably the most well-known builder of high-end equipment, created the Momentum preamp in order to best work with Momentum amplifiers.

The construction of this preamp is based on assumptions, which are also the basis for the construction of power amplifiers. First, there was used the most perfect project ever came from the hand of Dan D’Agostino. Second, the construction of each unit shall be precise technique, which the rest of the industry have long since given up selecting cheaper and faster automated assembly. Thirdly, placed emphasis on achieving maximum performance with minimal power consumption. And finally, fourth: the quality of the housing Momentum arouse jealousy is even in the best of Swiss watch makers

Innovative features The preamplifier is equipped with a meter, we know the power amplifiers Momentum. Its design was inspired watches Breuget shield. It shows basic information about pre-settings.

Boldest move, Dana D’Agostino is an introduction to the structure of the Momentum preamp tone control. This function was abandoned in the industry many years ago. Poorly designed systems for deteriorating sound quality of high-end preamps. However, D’Agostino longed for color control utility that allows you to correct the mistakes of weaker recordings.

To create a bass level control and treble, D’Agostino tried a number of filters, which allowed him to find the ones that sound the most musically. Then he brought them to the preamp design using the best available components. The result of this work is the ability to dramatically improve the sound recordings made less. Of course, if you do not use color control system can be completely excluded from the signal path

Round Remote allows you to remotely control all functions of the preamplifier. It uses radio waves – it has therefore also through the walls.

Robust construction Dan D’Agostino has applied to build Momentum preamp only discrete components. The signal path is not a single operational amplifier. The total lack of feedback loop provides the best sound musicianship. The volume control is responsible optically controlled resistor ladder – is the purest and most transparent sonically gain control method.

All electronic components embedded in the motherboard hole mounting method, which is more expensive than the popular surface mount technology today, but it provides better results sound and increases the durability and stability of the finished device.

A power supply circuit is closed 300VA in a separate case at the same time which is the basis for the reinforcement signal. With such a delicate part of the structure design regulates the sound level is insulated from interference and electromagnetic noise. Some pre-control is separate from the power of dealing with the processing of the audio signal. This enables a complete separation of the two systems and signal control.

Each stereo preamplifier Momentum is built and tested by hand in the factory business in Connecticut.

 

SPECIFICATIONS:

BANDWIDTH:  1 Hz to 1 MHz, -1 dB / 20 Hz to 20 kHz, ± 0 dB
DISTORTION: <0.006%, 20 Hz to 20 kHz
S / N RATIO: 105dB, unweighted
GAIN: 6 to 12 dB, adjustable
POWER CONSUMPTION IN THE READY: <1 watt
INPUT:  6 inputs XLR Stereo zbalanowanych  OUTPUT:  1 balanced stereo XLR
DIMENSIONS (PREAMPLIFIER):  10.8 x 45 x 30 cm (H x W x D)
DIMENSIONS (POWER / BASE):  7.5 x 27.5 x 20 cm (H x W x D)
WEIGHT:  18 Kg with power

AccA inc 、YG Acousticsの国内製品価格を値上げへ。5月1日より。

国内ニュース速報 [Japan]

お取引先様各位

 

前略

平素は格別のご高配を賜り、深く御礼申しあげます。

 

さて急劇な為替変動に伴い、平成25年度、5月1日よりYG ACOUSTICS社製品の希望小売価格を

添付ファイルの通り変更させて戴きます。

誠に恐縮では御座いますが、御理解の程、宜しくお願い申し上げます。

 

YGACOUSTICS

 

ygp

JeffRowland、新プリメインアンプContinuum S2はオプションボードにてDAC・phono stageに対応。

海外ニュース速報 [World]

JeffRowlandから発売予定の新プリメインアンプContinuum S2は、オプションボードにて、USB対応DAC・phono stageを追加搭載可能に。2013年夏発売予定。

Lehmann audioから、ポータブルヘッドフォンアンプ登場。

海外ニュース速報 [World]

Lehmann audioから、ポータブルヘッドフォンアンプが登場です。
2013年 第一四半期発売予定。

*以下はドイツ語を自動翻訳エンジンにて英語に変換しております。

Headphone amplifier specialist Lehmannaudio mobility – with a portable headphone amplifier in a class. The new Traveler provides the best sound on the go. Who supplied in this way with your favorite music enjoys traveling comes automatically relaxed.   This latest – and smallest – scion of the Lehmann Audio headphone amplifier family is completely analogous, as always, has at Lehmann audio only very high quality components on the board and is sonically a sophisticated high-performance circuit.   The Traveler has only two controls on the front page, with which all functions can be controlled intuitively. The volume adjustment is made by pressing a button. It is possible, the optimal position of the acoustic center of the “Center Adjust” to adjust without deteriorating with additional electronics in the signal path, the music playback. This allows non-uniform source material to be aligned or personal preferences or physiological conditions of each listener into account. By the perfect channel match the integrated resistor network a gain switch is unnecessary.

A high-capacity lithium-polymer battery provides a runtime of about 15 – 20 hours – enough to survive even the longest transatlantic flight without charging! For this, only one USB port is required. The appropriate cable is included with the device. Likewise included is a high quality mini-jack cable.   The electronics used is so good that the Traveler can be safely used as a preamplifier for connection to a stereo or powered speakers. Input and output jacks are mounted by the renowned manufacturer and Lumberg on both the front and on the back. This allows complete freedom when connecting the cables.   The device should have in the first quarter of 2013 go on sale. Further information is available at the Lehmann GmbH Sales

lehmannaudio

« 古い記事 新しい記事 »