海外ニュース速報 [World]
LINN Kandid MCカートリッジ： £2950 ４月発表予定
限定数量生産で納品は発注後６ヶ月以上かかる見込み。
Linn Kandid brings a new standard in excellence. 40 years after the introduction of the Linn Sondek LP12, Linn are delighted to announce the arrival of the best sounding cartridge they have ever made – Linn Kandid.
One of the key performance improvements comes as a result of removing the cartridge housing – probably also the most striking aesthetic difference Linn have made to Kandid. Stripping back the housing to expose the motor assembly has resulted in an even purer, cleaner sound than ever before.
More accurate audio reproduction is achieved thanks to the repositioning of the stylus and cantilever within the body of the cartridge. The angle of the magnets and coil in the front pole piece has been off-set so that they are parallel when the record is playing which ensures perfect alignment for accurate movement on the record.
Kandid is the perfect partner for the Linn Ekos SE tonearm. The chassis is machined from the same aircraft grade aluminium as the Linn Ekos SE headshell and features their 3-point mount for completely rigid and accurate coupling with the tonearm.
Limited availability
Linn’s production capacity for Linn Kandid cartridges is limited and as we anticipate very high demand for this product, the lead time for delivery could be up to 6 months, so it’s advisable to place orders as soon as possible.
Specifications:
•Cartridge type: Low output moving coil
•Stylus and cantilever: Slot mounted, 3um x 70um nude line contact diamond in boron cantilever
•Vertical tracking angle: 20 degrees
•Tracking force: 1.72g – 1.77g (1.75g preferred)
•Pin connection type: Flying wire with termination clips
•Recommended load: 70Ω ~ 1kΩ (determine optimum by listening)
•Separation at 1kHz: Better than 35 dB
•Channel balance at 1 kHz: +/- 0.5 dB
•Output at 1 kHz @3.45 cm/s: 0.4 mv
•Weight: 5.7 g (without stylus cover)
国内ニュース速報 [Japan]
Avalonの新フラグシップ、tesseractが国内登場です。
テッサラクト
\40,380,000(税別) 予価 2013年7月～8月出荷予定
海外ニュース速報 [World]
TECHNICAL SPECIFICATIONS
POWER SUPPLY
· Nominal Line Voltage 117 ; 234V
· AC line range: 10%
· Fuse 16A for 115 and 230V
· 10 toroidal transformers
· Separated ground and earth signal
· Connection between earth and ground to cancel all ground loops
Rated power consumption:
· IEC 60065, 1/8 Output Power at 8 Ω: 210 W
Max power consumption:
· IEC 60065 at 8 Ω /1% THD: 550 W
FRONT PANEL
· 2 control keys
· Red led display for Over-heating, DC offset or HF protection and Overload
· Green led display for Power ON, operating mode
· Yellow led display for AC line connection and digital Lock
· Yellow led display for Standby Mode
REAR PANEL
· Power cord: universal socket 3 lugs
· Main fuse (16 A slow-blow)
· Green-yellow AC earth binding post
· Output speaker 1 x 5 ways post
· Output speaker 1 x coaxial connector
· Analog Input connector RCA
· Input connector XLR for analog balanced input
· Digital input and output RCA connector
INPUT
Max level before clipping:
· Analog input: 1Vrms
· Digital input: – 6 dBFS
OUTPUT
Max level before clipping:
· 1 % THD, unloaded: 153 Vpp
PERFORMANCE
Output power:
· Power RMS (Goldmund FPP Standard): 350 Wrms on 8 Ω.
· Maximum power (IEC60065): 335 Wrms on 8 Ω / 1%THD
Bandwidth:
· 20Hz – 20KHz: +/-0,03dB, unloaded
· +/- 3dB: 0Hz to 100 kHz (limited by protection circuitry), unloaded
Slew rate:
· Unloaded,18V/μS
Distorsion:
· IMD (SMPTE), unloaded: < 0.03 %
· THD+N, unloaded: < 0.06 % from 20 Hz to 20 kHz at 20 Vrms output
Output noise floor:
· Analog input terminated with RCA Shorting Caps, unloaded: < 3 μV from 20 Hz to 20 kHz
Gain:
· 35dB
Dynamic range:
· 22 kHz measurement bandwidth (flat), true RMS unloaded: 110 dB
Damping factor:
· at 8 Ω: > 160 from 20 Hz to 20 kHz
DIMENSIONS
· 330 W x 470 D x 270 H (mm)
WEIGHT
· Weight: 65 kg
WARRANTY
· 3 years parts and labo
goldmund_telos_500_user_manual
海外ニュース速報 [World]
＊日本国内での発売開始時期については未定です。
＊以下は、自動翻訳エンジンにて英語に変換しております。
Preamplifier MOMENTUM
Why only the Momentum preamp can match the exceptional quality amplifiers Momentum? Because it is the only preamp built according to the same standards. Dan D’Agostino, probably the most well-known builder of high-end equipment, created the Momentum preamp in order to best work with Momentum amplifiers.
The construction of this preamp is based on assumptions, which are also the basis for the construction of power amplifiers. First, there was used the most perfect project ever came from the hand of Dan D’Agostino. Second, the construction of each unit shall be precise technique, which the rest of the industry have long since given up selecting cheaper and faster automated assembly. Thirdly, placed emphasis on achieving maximum performance with minimal power consumption. And finally, fourth: the quality of the housing Momentum arouse jealousy is even in the best of Swiss watch makers
Innovative features The preamplifier is equipped with a meter, we know the power amplifiers Momentum. Its design was inspired watches Breuget shield. It shows basic information about pre-settings.
Boldest move, Dana D’Agostino is an introduction to the structure of the Momentum preamp tone control. This function was abandoned in the industry many years ago. Poorly designed systems for deteriorating sound quality of high-end preamps. However, D’Agostino longed for color control utility that allows you to correct the mistakes of weaker recordings.
To create a bass level control and treble, D’Agostino tried a number of filters, which allowed him to find the ones that sound the most musically. Then he brought them to the preamp design using the best available components. The result of this work is the ability to dramatically improve the sound recordings made less. Of course, if you do not use color control system can be completely excluded from the signal path
Round Remote allows you to remotely control all functions of the preamplifier. It uses radio waves – it has therefore also through the walls.
Robust construction Dan D’Agostino has applied to build Momentum preamp only discrete components. The signal path is not a single operational amplifier. The total lack of feedback loop provides the best sound musicianship. The volume control is responsible optically controlled resistor ladder – is the purest and most transparent sonically gain control method.
All electronic components embedded in the motherboard hole mounting method, which is more expensive than the popular surface mount technology today, but it provides better results sound and increases the durability and stability of the finished device.
A power supply circuit is closed 300VA in a separate case at the same time which is the basis for the reinforcement signal. With such a delicate part of the structure design regulates the sound level is insulated from interference and electromagnetic noise. Some pre-control is separate from the power of dealing with the processing of the audio signal. This enables a complete separation of the two systems and signal control.
Each stereo preamplifier Momentum is built and tested by hand in the factory business in Connecticut.
SPECIFICATIONS:
BANDWIDTH: 1 Hz to 1 MHz, -1 dB / 20 Hz to 20 kHz, ± 0 dB
DISTORTION: <0.006%, 20 Hz to 20 kHz
S / N RATIO: 105dB, unweighted
GAIN: 6 to 12 dB, adjustable
POWER CONSUMPTION IN THE READY: <1 watt
INPUT: 6 inputs XLR Stereo zbalanowanych OUTPUT: 1 balanced stereo XLR
DIMENSIONS (PREAMPLIFIER): 10.8 x 45 x 30 cm (H x W x D)
DIMENSIONS (POWER / BASE): 7.5 x 27.5 x 20 cm (H x W x D)
WEIGHT: 18 Kg with power
国内ニュース速報 [Japan]
お取引先様各位
前略
平素は格別のご高配を賜り、深く御礼申しあげます。
さて急劇な為替変動に伴い、平成25年度、5月1日よりYG ACOUSTICS社製品の希望小売価格を
添付ファイルの通り変更させて戴きます。
誠に恐縮では御座いますが、御理解の程、宜しくお願い申し上げます。
YGACOUSTICS
