Sonus faberから、「 Venere S 」登場!!

海外ニュース速報 [World]

Sonus faber Venere S

Black/White: € 4.100,00
Walnut: € 4.300,00

Aluminum details

The brushed aluminium around each driver gives a dash of character to the speaker’s front facade.
The glass base found on the other Venere models is replaced by a brushed black aluminium plate with diamond edge to further energize the look of Venere S.

REFLEX PORT

A new design for the reflex port fitted it in the lower part of the cabinet, directly facing the floor. This way the purity of the sound is not contaminated by the spurious vibrations generated by its powerful drivers.

WOOFERS

The three woofers cones of Venere S are made of aluminium, providing for maximum lightness and stiffness of the transducers to achieve a fast response to transients at low frequencies.

 

LOUDSPEAKER SYSTEM
3 way floorstanding speaker.

TWEETER
29mm high definition precoated fabric dome driver. DKM dome diaphragm visco-elastically decoupled from the baffle. Sonus faber design.

MIDRANGE
1x150mm cone driver. Ultra free compression basket, Sonus faber design. Thermo-mouldered polypropylene textile cone (Curv). Ultra dynamic performance and linearity. Special coaxial anti-compressor is used to remove resonances and distortions. Sonus faber design.

WOOFER
3x180mm cone driver. Free compression basket, Sonus faber design. Sonus faber design.

CROSS-OVER
Non-resonant “progressive-slope” design, optimazed phase response for optimal space/time performance, “paracorss topology” on every network. (Nano-technology deposition on the pcb rails). Cross-over point: 250Hz – 2500 Hz.

FREQUENCY RESPONSE
40 Hz -25.000 Hz

SENSITIVITY (2.83V/1m)
90dB SPL

NOMINAL IMPEDANCE
4 ohm

SUGGESTED AMPLIFIER OUTPUT
40W – 300W without clipping

LONG-TERM MAX INPUT VOLTAGE (IEC-268-5)
22V rms

TOTAL DIMENSION (HxWxD)
1.236 x 391x 477,5 mm

WEIGHT
28,8 Kg

SonusFaberST17_0132Edit

SonusFaberST17_0040Edit(0)

SonusFaberST17_0063Edit

SonusFaberST17_0129Edit(0)

SonusFaberST17_0138Edit

« »